Note: Notes:FVAL, as defined in the Camera Link standard, is not used. FVAL is permanently tied to 0 (low) level. DVAL is not used. DVAL is permanently tied to 1 (high) level. In case of Single output, the data (multiplexed) are output in place of Odd data. 9.4 Serial Communication The Camera Link interface provides two LVDS signal pairs for the communication between the camera and the frame grabber. This is an asynchronous serial communication based on RS-232 protocol. The configuration of the serial line is: ? Full duplex/without handshaking
? 9600 bauds, 8-bit data, no parity bit, 1 stop bit. 9.4.1 Command Syntax The valid syntax is "S = n(CR)" with: ? S: command identification as per “Camera Command and Control” on page 5. S is a single character in upper case.
? n: setting value. ? (CR): means "carriage return". no space, nor tab may be inserted between S, =, n and (CR). Example of a valid command: ? G = 3(CR): sets the camera to gain 3 (refer to “Camera Command and Control” on page 5 for exact value calculation). Example of non valid commands: ? G = 3(CR): spaces ? g = 3(CR): g instead of G ? G = 1040(CR): 1040 is outside of range 9.4.2 Command Processing Each command received by the camera is processed:
? If the command is valid: – the setting is done in case of a write command. – the camera returns the data separated by (CR) in case of the read command. – the camera returns: >OK(CR). ? If the command is not valid: – nothing is done. – the camera returns: >1 = out of range; >2 = syntax error; >3 = command too long; >4,>6,>7 = internal error; >5 undefined function.
Example: when receiving "! = 3(CR)’’ the camera returns its current settings:
? A = 0(CR); B = 0(CR); ....; E = 0(CR); >OK(CR). 9.5 Storage of the Settings in EEPROM e2v recommends to use "E = 1" for settings that are often changed (check the maximum number of write cycles above) and when the time required by the camera to process a command is critical. The maximum number of write cycles allowed for the EEPROM is: 100 000. 10. Connector Description All connectors are on the rear panel. Note: Cables for digital signals shall be shielded twisted pairs. 10.1 Power Supply Camera connector type: Hirose HR10A-7R-6PB (male). Cable connector type: Hirose HR10A-7P-6S (female). Figure 10-1. Receptacle Viewed from Camera Back 10.2 Camera Link Connector Standard Camera Link cable shall be used to ensure the full electrical compatibility. Camera connector type: MDR-26 (female) ref. 10226-2210VE. Cable connector type: Standard Camera Link cable shall be used (ex. 3M - 14B26-SZLB-x00-OLC). Table 10-1. Power Supply Connector Pin-out
