廣大消費者在使用清洗設備期間，請做好日常保養工作，以免出現問題并且造成設備壽命減短的后果，影響設備創造價值。
全自動鞋底清洗機風淋室鞋底清潔機
鞋底清洗機作為一種入口鞋底清潔設備，旨在解決由鞋底帶進室內的污塵問題。通過鞋底清潔機自動感應啟動，浸濕的履帶毛刷旋轉摩擦鞋底，從而清理掉鞋底污塵，將污塵阻擋在入口處，減少室內地面清潔工作量，為保持室內環境潔凈度樹立一道屏障。
As an entry sole cleaning equipment, sole cleaning machine aims to solve the problem of dirt brought into the room by the sole. Through the automatic induction start of the sole cleaner, the wet crawler brush rotates and rubs the sole, so as to clean up the dust on the sole, block the dust at the entrance, reduce the indoor floor cleaning workload, and establish a barrier to maintain the cleanliness of the indoor environment.
安裝要點
——
選用綠源（東莞）科技有限公司的企業亦或是上市集團公司，請在投入使用安裝擺放時請嚴格遵守安裝要點，以免產生不必要的麻煩，此舉不僅是對雙方負責也是對勞動成果的尊重。
①、務必確保設備整體水平放置無晃動傾斜，如不水平可通過調節活動支腳來改變。
②、務必確保插座接地并且電壓為110V或220V，電壓如果偏低會造成設備運轉不正常。
③、務必確保進排水管及電源線理順無任何折壓不暢。
④、多臺設備并排，請確保每臺機每條排水管，水壓至少達到0.5Mpa
Whether you are an individual, a small enterprise, a medium-sized enterprise, a large enterprise or a listed group company, please strictly abide by the key points of installation when putting into use and installation to avoid unnecessary troubles. This is not only the responsibility of both parties, but also the respect for the results of labor.
①、make sure that the equipment is placed horizontally without shaking and tilting. If it is not horizontal, it can be changed by adjusting the movable feet.
②、make sure that the socket is grounded and the voltage is 110V or 220V. If the voltage is low, the equipment will not operate normally.
③、make sure that the water inlet and drain pipes and power lines are smooth without any buckling.
④、Please ensure that the water pressure of each drain pipe of each unit is at least 0.5MPa
問題解答
——
根據近幾年東莞市合瑞電子科技有限公司客戶使用反饋情況以及我們不間斷的巡視了解，比較集中的情況總結下來，給所有使用的客戶作為參考，其實很多根本就不是什么問題，只是操作使用不當或者疏忽造成的麻煩。
一、設備不工作或跳閘
①、檢查電源是否打開，漏電保護插頭開關是否處于打開
②、檢查電源線是否斷裂破損
③、檢測電壓是否能夠達到要求
④、檢查感應器端口是否插好
⑤、檢查感應器是否會閃爍紅色燈光，正常情況下是閃爍幾秒鐘之后不閃爍
⑥、檢查控制盒是否亮燈，正常情況下是6號燈亮（手動模式）或5號燈亮，打開了缺水提示的3號燈也會亮，其他燈不會亮
⑦、檢查鏈條是否斷裂
⑧、檢查是否有異物卡死鏈條或者滾軸
二、設備出現異響
①、檢查鏈條和齒輪是否完好，不定期要加注潤滑油
②、檢查主動軸和從動軸兩端的軸承是否完好
③、檢查迪阿尼是否有松動
④、水泵有異響，可拆開水泵檢查下內部是否有鐵砂
三、設備進排水問題
①、設備不排水，通過以下幾點可找出故障原因：檢查排污水管是否理順無折壓、檢查水泵整條線是否完好并且各端口插好，檢查水泵是否有反應損壞、手動模式檢查排水按鈕是否損壞
②、排污水泵一直工作，通過以下幾點可找出故障原因：檢查控制器是否進水，檢查排水按鈕是否進水出現了短路
③、設備不進水，通過以下幾點可找出故障原因：檢查水管內是否有水供應，檢查水位感應器是否亮燈進水，檢查進水電磁閥是否有動作
According to the feedback of customers' use in recent years and our continuous inspection and understanding, the situation is relatively concentrated and summarized. As a reference for all customers, many of them are not problems at all, but problems caused by improper operation or negligence.
1、 Equipment does not work or trips
①、Check whether the power supply is turned on and whether the leakage protection plug switch is turned on
②、Check whether the power cord is broken
③、Check whether the voltage can meet the requirements
④、Check whether the sensor port is plugged in properly
⑤、check whether the sensor will flash red light. Normally, it does not flash after a few seconds
⑥、Check whether the control box lights up. Normally, No. 6 light is on (manual mode) or No. 5 light is on. No. 3 light will also be on when the water shortage alarm is turned on, and other lights will not be on
⑦、Check whether the chain is broken
⑧、Check whether there is any foreign matter blocking the chain or roller
2、 Abnormal noise of equipment
①、 Check whether the chain and gear are in good condition, and add lubricating oil irregularly
② 、Check whether the bearings at both ends of the driving shaft and driven shaft are in good condition
③ Check whether deani is loose
④ 、If the water pump makes abnormal noise, disassemble the water pump to check whether there is iron sand inside
3、 Water inlet and drainage of equipment
①、if the equipment is not drained, the cause of the failure can be found out through the following points: check whether the drain pipe is straightened out and free of pressure break; check whether the whole line of the water pump is intact and all ports are plugged in; check whether the water pump is damaged in response; check whether the drain button is damaged in manual mode
②、the blowdown water pump has been working, and the cause of the fault can be found out through the following points: check whether the controller is filled with water, check whether the drainage button is short circuited in water
③、if there is no water in the equipment, the cause of the fault can be found out through the following points: check whether there is water supply in the water pipe, check whether the water level sensor lights up and water enters, and check whether the water inlet solenoid valve acts
日常維護
——
廣大客戶在使用清洗設備期間，請做好日常保養工作，以免出現問題并且造成設備壽命減短的后果，影響設備創造價值。
日常清潔保養
①、室外鞋的請務必每天徹底清理一次污水池內和水泵槽內垃圾及泥沙，通過吸塵器把泥沙吸出，換鞋的可隔天徹底清理一次。間隔性的清理皮帶毛刷，可通過手提水倒進毛刷處沖洗
②、三個月請對鏈條齒輪加注潤滑油
③、不定期對設備表面進行擦洗清潔
④、根據自身使用情況對吸水墊清洗更新
During the use of cleaning equipment, customers should do a good job in daily maintenance to avoid problems and the consequences of shortening the service life of the equipment, which will affect the value creation of the equipment.
Daily cleaning and maintenance
① For outdoor shoes, please clean the garbage and sediment in the sewage tank and water pump tank once a day. It is better to suck the sediment out through the vacuum cleaner. For shoes changing, you can clean them thoroughly every other day. The belt brush can be cleaned by interval, and it can be washed by hand-held water pouring into the brush
② 3 months, please add lubricating oil to the chain gear
③ . clean the equipment surface irregularly
④ Clean and update the absorbent pad according to its own use
日常使用操作移動過程中，禁止控制盒進水，禁止設備清洗區混入鐵釘、刀片、電子元件等銳利固體。
In the process of daily use and operation, it is forbidden to allow water into the control box, or sharp solids such as nails, blades and electronic components to be mixed in the equipment cleaning area.
