泵壓力表 KBY
Pump pressure gauge KBY
產品簡介
KBY-1A型壓力表，主要用于水泵、泥漿泵、排污泵等各類工程施工配套使用?？晒┑刭|(zhì)、煤碳、冶金、化工、水電、輕工、環保及工程施工系統，在生產過程中測量泵壓以及壓力變化。
該表具有以下特點：
1、耐震性能良好。并能承受測量范圍內的瞬間壓力沖擊；
2、良好的阻尼特性?？蓽y(cè)量脈動介質的瞬間壓力平均值；
3、防“堵”性能優異。對高粘度、易結晶、含顆粒狀和纖維狀物質以及油污等復雜介質，具有較強的適應性；
4、儀表采用全密封結構，可在高濕度、粉塵、污濺以及淺水中等惡劣環境中工作；
5、全金屬外殼體和器件，堅固可靠；
6、外形美觀，度盤清晰。
PRODUCT OVERVIEW
YBY-1A-type pressure gauge, mainly for water pumps, mud pumps, sewage pumps and
other construction necessary use. For geology, coal, bllurgy, chemical industry, water,electricity, light industry, environmental protection and construction systems, in the production process and the pressure pump pressure measurement.
The table has the following characteristics:
1, the seismic perbance is good. Measuring range and can withstand the impact of the instantaneous pressure;
2, good damping characteristics.Measure the pulse of the average instantaneous pressure medium;
3, anti-"blocking" perbance. The high viscosity and crystallization, with granular and fibrous material, and oil and other complex media, with a strong adaptability;
4, instrument Fully sealed structure, high humidity, dust, dirt and splashing in shallow water medium harsh environment;
5, full bl body and components, solid and reliable;
6, beautiful appearance, b dial.
主要技術參數
1、表頭公稱尺寸（㎜）￠116（整體幾何尺寸116×234×54）
2、系列產品測量范圍及精度等級
|
測量范圍MPa |
精度等級 |
|
0-1、0-1.6、0-2.5、0-4、0-6、 0-10、0-16、0-25、0-40、0-60 |
2.5 |
3、工作環境溫度 -10～45℃ 相對濕度 ≦90%
4、介質脈動頻率20～50次/分
5、環境震動頻率≦25HZ； 震動范圍 ±0.5㎜
6、安裝螺紋 M20×1.5
Specifications
1 meter Nominal Size (mm) ¢ 116 (the overall geometry of 116 × 234 × 54)
2, the series measurement range and accuracy classRange MPa accuracy class
0-1,0-1.6,0-2.5,0-4,0-6,
0-10,0-16,0-25,0-40,0-60 2.5
3, Working temperature -10 ~ 45℃Relative Humidity≦90%
4, medium pulsation frequency of 20 to 50 times / min
5, environmental vibration frequency≦25HZ; vibration range of ± 0.5 mm
6 Mounting thread M20 × 1.5
結構及工作原理
KBY-1A型壓力表，由介質轉換器（或稱隔離器）和表頭組成。
介質轉換器主要組件有：器體、橡膠隔膜（隔膜上部充20#機油或不同粘度的甲基硅油為工作油，使隔膜變呈Ω狀）、注油接頭、安裝接頭等；表頭由彈簧元件、傳動機構、度盤、阻尼器以及殼體組成。表頭內腔充粘度為300-500cs的甲基硅油。
被測介質的壓力推動隔膜，介質轉換器中的工作油以同等壓力使彈簧元件自由端產生相應的位移，經傳動機構，表針旋轉指示出被測介質的壓力值。
Structure and working principle
KBY-1A-type pressure gauge, by the media converter (or isolation) and the header component.
Media converters main components are: device body, the rubber diaphragm (diaphragm or the upper part of the oil charge of 20 # methyl silicone oil of different viscosity oil for the work, so that change was Ω-shaped membrane), grease fittings, installation and other joints; Meterby the spring element, transmission, dial, dampers, and shell comb.Header cavity filling for the 300-500cs viscosity of methyl silicone oil.
The pressure measured media to promote the diaphragm, media converters work in the oil to the same pressure to produce the corresponding free end of the spring element of displacement, the transmission mechanism, hands rotate indicate the pressure value measured media.
使用注意事項
1、被測介質壓力應不大于所選用儀表測量上限的3/4；
2、儀表垂直安裝為宜；
3、使用過程中，嚴禁拆動各零、部件；
4、若出現表頭內腔充油漏失嚴重或介質轉換器內工作油滲漏，以及隔膜破裂等情況，應及時停用；
5、開箱后的儀表應放在下述環境中保管；
（1） 環境溫度+5～45℃；
（2） 相對濕度≦85%；
（3） 空氣中不應含有腐蝕性氣體和雜質；
6、存放一年以上的儀表，啟用前應進行檢測。
Caution
1, measured media pressure should not exceed the maximum measurement instrument of
choice 3 / 4;
2 meter vertical installation is appropriate;
3, the use, is strictly prohibited dismantled parts and components;
4, If there is severe leakage meter oil-filled cavity or media converter to work the oil leakage,and membrane rupture, etc., should be bly suspended;
5, after the meter box shall be kept on the following environments;
(1) Ambient temperature +5 ~ 45℃;
(2) relative humidity≦85%;
(3) the air should not contain corrosive gases and impurities;
6, stored more than one year of the instrument, should be detected before the opening.
歡迎致電咨詢訂購泵壓力表
電話:010-51669912 56291930 15910733293
傳真：010-51669912
QQ：823377546 1491421115 2636968574
郵箱:sales@zoriver.cn
公司官網：http://www.zoriver.cn http://www.zoriver.cm.cn
